SPONSORS
2024 ICRBE EXPO |
Help With Ferrule Wrap With Guide
Posted by:
Kerry Burgess
(---.dhcp.embarqhsd.net)
Date: June 08, 2014 07:39PM
Need to wrap a ferrule (tip-over-butt) that has a guide very close to the female end. I read number 14 of the FAQs. That would work out well. I also read what Dale Clemens wrote that a 1/4 wrap would suffice but not look good. So most wrap the entire ferrule to length of the male penetration plus 1/4 inch or to the point where the diameter reduces to the normal taper of the blank.
On this blank the male end penetrates 3 - 5/8 inch. Measuring 3 - 5/8 inch of the tip section places it (male tip) right under the guide ring. This is a surf spin that will have a 4-5 oz weight plus bait. I've used the 27x spacing method. Moving the guide IMO is out of the question. Suggestions anyone???? Re: Help With Ferrule Wrap With Guide
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: June 08, 2014 07:53PM
if you don't trust one wrap
Do the Ferrule wrap Coat with several coats of say permagloss then wape all the guides on and use your finish Bill - willierods.com Re: Help With Ferrule Wrap With Guide
Posted by:
Tom Kirkman
(Moderator)
Date: June 08, 2014 09:18PM
You can put a guide on top of a ferrule wrap. And, the ferrule wrap doesn't have to be very long. Your choice.
................. Re: Help With Ferrule Wrap With Guide
Posted by:
Kerry Burgess
(---.dhcp.embarqhsd.net)
Date: June 08, 2014 10:00PM
Thanks. Sorry, only registered users may post in this forum.
|