SPONSORS
2024 ICRBE EXPO |
Taperline by backlash
Posted by:
bill brodrick
(---.cmts.sth3.ptd.net)
Date: December 16, 2013 02:13PM
Does anyone know if Lynn Williams ever went forward with his guide alignment tool. I think he was calling it the Taperline. I have wanted one since first seeing it at the show a few years ago and cannot find it. If anyone knows anything please help me get one. Re: Taperline by backlash
Posted by:
Tom Kirkman
(Moderator)
Date: December 16, 2013 03:27PM
No he didn't. Not yet, anyway. The cost to produce it was much more than he felt he could sell it for. He may be exploring some alternative solutions but I haven't talked to him about it in some time.
............... Re: Taperline by backlash
Posted by:
bill brodrick
(---.cmts.sth3.ptd.net)
Date: December 16, 2013 03:47PM
Thanks Tom. I love the concept of the one part of rod building that takes me way too much time. Re: Taperline by backlash
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: December 16, 2013 04:23PM
Do you really need a guide alianment tool ??
Guides up Eye them Guides down use the blank as Center Do this Outside in good light works better I always put the tip top on first Line it to the seat and reel Then line all the rest to the top You can also get a bright colored fly line Use the thine running part run it though the guides with a little weight on the end Do you have Bad Vision ??? Bill - willierods.com Edited 2 time(s). Last edit at 12/16/2013 05:17PM by bill boettcher. Re: Taperline by backlash
Posted by:
Randolph Ruwe
(---.hsd1.wa.comcast.net)
Date: December 16, 2013 06:14PM
My guide alignment tool is the reel foot off of an old casting reel. I secure the foot in the reel seat on the rod, and I use a line level that is balanced in the foot and when the bubble is absolutely level, I tape the guides in place. Has worked for me for many years. Re: Taperline by backlash
Posted by:
Tom Kirkman
(Moderator)
Date: December 16, 2013 06:28PM
A perfectly straight line exactly drawn down one axis of the blank can be quite helpful. It can be done, but the tool to do it, for what Lynn feels is an affordable price is still a bit off.
............. Re: Taperline by backlash
Posted by:
Barry Chapman
(---.41.70.115.static.exetel.com.au)
Date: December 16, 2013 08:17PM
I have the same setup as Randolph & have done so for years also .I also use a laser level if I need a line down the rod .I have a centre line scribed into one of the chuck jaws ,line up the level with this mark & run the level down the blank marking as I go & then run a piece of thread making sure that it touches each mark. As I always use the laser during setup the extra time taken is measured in seconds. Regards Baz Bundeena NSW Australia Edited 1 time(s). Last edit at 12/16/2013 08:21PM by Barry Chapman. Sorry, only registered users may post in this forum.
|