SPONSORS
2024 ICRBE EXPO |
Alps Centra lok
Posted by:
John Jack
(---.as13285.net)
Date: August 14, 2013 09:42AM
Just bought an Alps with a central carbon sleeve, now think maybe I jumped as little too far, How do I fit this to the blank without movement of the reel seat and getting fix on the viewable sleeve. Re: Alps Centra lok
Posted by:
Forrest Peters
(---.wi.res.rr.com)
Date: August 14, 2013 11:58AM
I just got mine on by degrease the inside of the seat itself. Then I used dry wall tape cut it into three pieces. Take scotch brite and water break the ends of the insert. Put the insert onto the tape to check for fit. Then glued with rod bond the insert onto the tape,then put rod bond on the far end and slide the seat over the insert far enough to get the rod bond on the other side of the insert, I let it sit over night and did some tests to make sure it was completely bonded.
It worked well hope you get the same results. Lone Wolf Rods "Keep your powder dry and your lines wet" God Bless Re: Alps Centra lok
Posted by:
John Jack
(---.as13285.net)
Date: August 14, 2013 12:07PM
Thank you
John Re: Alps Centra lok
Posted by:
Forrest Peters
(---.wi.res.rr.com)
Date: August 14, 2013 01:49PM
No problem. That is what this forum is all about. Lone Wolf Rods "Keep your powder dry and your lines wet" God Bless Sorry, only registered users may post in this forum.
|