SPONSORS
2024 ICRBE EXPO |
Pac Bay wrapper question?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: August 12, 2013 10:43AM
What is the height of the chuck centerline from the base of the head stock on the standard Pac Bay wrapper?
I know that the bed has height. I am not asking about the bed height. But from the top of the lathe bed, what is the distance to the center of the rod if the rod is in the jaws of the chuck? Thanks much Re: Pac Bay wrapper question?
Posted by:
philip hardy
(---.oxfd.adsl.virginmedia.com)
Date: August 12, 2013 10:52AM
I make it circa 115mm Re: Pac Bay wrapper question?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: August 12, 2013 12:07PM
Phillip.
Thanks much. I believe that would equal 4.52 inches. Re: Pac Bay wrapper question?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: August 12, 2013 12:37PM
Actually it is 4.52756 inch LOL Bill - willierods.com Re: Pac Bay wrapper question?
Posted by:
Bill Falconer
(---.dhcp.unas.al.charter.com)
Date: August 12, 2013 02:14PM
Roger, I think the above measurement is from the top of the 'channel' all the attachments mount to. If you measure from the bottom of that channel, it is 5.625" from the base to the centerline of the chuck / headstock.
This is on a PacBay lathe purchased less than 6 months ago. Hope this helps...thanks! Bill Sorry, only registered users may post in this forum.
|