SPONSORS
2024 ICRBE EXPO |
Guide checking
Posted by:
Ed Fontes
(---.hsd1.ma.comcast.net)
Date: July 25, 2013 12:02PM
I was going through an old post about epoxies and someone commented that there was a way to stop checking at the guide feet on heavy rods, he did not tell how, can anyone give the answer? Re: Guide checking
Posted by:
Tom Kirkman
(Moderator)
Date: July 25, 2013 02:49PM
I'm not aware of any way to completely eliminate it, but if you are careful to grind/shape the ends of the guide feet to a very shallow taper you will most likely prevent it to at least some measurable degree.
................. Re: Guide checking
Posted by:
Bruce Tomaselli
(---.altnpa.east.verizon.net)
Date: July 25, 2013 06:45PM
What is guide checking?
Thanks Re: Guide checking
Posted by:
Tom Kirkman
(Moderator)
Date: July 25, 2013 07:51PM
Small cracks in the finish at the ends of the guide feet.
.............. Sorry, only registered users may post in this forum.
|