SPONSORS
2024 ICRBE EXPO |
CP question - open wraps
Posted by:
Mike Rademacher
(---.dyn.optonline.net)
Date: July 15, 2013 11:35PM
Howdy all
Quick question... just finished my first decorative wrap... it an open wrap (elongated chevrons) using Madeira thread... i plan on a few coats of CP (chromaseal) but have a question... when coating a large open wrap do folks recommend only coating the threads or do you cover the whole section of the wrap including the exposed blank with the CP... what are best practices here if anyone can share their experience. thanks mike Re: CP question - open wraps
Posted by:
Forrest Peters
(---.wi.res.rr.com)
Date: July 16, 2013 02:06AM
I cover the whole section. Never had a issue. Lone Wolf Rods "Keep your powder dry and your lines wet" God Bless Re: CP question - open wraps
Posted by:
Col Chaseling
(---.lns5.ken.bigpond.net.au)
Date: July 16, 2013 02:37AM
Hi Mike,
I do the same as Forrest. The following two both using madeira and chromaseal. [www.rodbuilding.org] [www.rodbuilding.org] ESFNEM Col Port Kembla, NSW Australia Edited 1 time(s). Last edit at 07/16/2013 02:39AM by Col Chaseling. Re: CP question - open wraps
Posted by:
Ken Finch
(204.45.65.---)
Date: July 16, 2013 07:27AM
I don't cover the open area of the blank. Re: CP question - open wraps
Posted by:
Andres Perez
(---.coastalsystemsint.com)
Date: July 16, 2013 11:27AM
I only cover the threads, but I don't think it really matters. Re: CP question - open wraps
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: July 16, 2013 11:57AM
I cover all the areas with CP. I do take some care to not leave large globs of CP on the open spaces. I pick up the excess with a dry brush on both the threads and the open spots.
Terry Re: CP question - open wraps
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 16, 2013 01:05PM
Mike,
Of course, you always have the option of using NO CP on the rod at all. I personally never use CP, unless a client makes a personal request for its use. I just prefer the look. Be safe Re: CP question - open wraps
Posted by:
Randolph Ruwe
(---.hsd1.wa.comcast.net)
Date: July 19, 2013 07:58PM
Roger, what thread are you using / NCP, Metalic, Regular or combinations of all three? Sorry, only registered users may post in this forum.
|