SPONSORS
2024 ICRBE EXPO |
Removing Reel Seat
Posted by:
Mark Iannacone Sr
(---.hsd1.nj.comcast.net)
Date: June 18, 2013 04:02PM
Hi everyone,I'm new posting to this forum but I've been lurking on here for a while.I'm going to try and build my own rods as a hobby.The question I have today is how do you get a reel seat off an old rod to be reused.I have a broken Lamiglas Surf Rod that I'd like to save the guides and reel seat.Any advise helpful.By the way,you guys build some beautiful rods. Re: Removing Reel Seat
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: June 18, 2013 05:06PM
Heat will usually soften the epoxy holding the seat on the blank. Assuming you are not attempting to salvage the blank, and depending upon the material, there are a couple of ways to approach the removal. 1, Use a heat gun. 2. boil it in water for 10 minutes or so. Then twist off. Be sure to use gloves or pads as you want to do this while it is hot. It may take more then one attempt to get it loose.
After you get it off, you will need to clean up the inside of the seat to remove old adhesive material. Edited 1 time(s). Last edit at 06/18/2013 05:07PM by Phil Erickson. Re: Removing Reel Seat
Posted by:
Don Morse
(---.dhcp.aldl.mi.charter.com)
Date: June 18, 2013 05:26PM
Cut the blank on each end of the seat and ream it out with a drill to fit the new blank...... BUT....seats are pretty inexpensive, I would buy a new one. ______________________________________ Super Tight Lines......Don Edited 1 time(s). Last edit at 06/18/2013 06:11PM by Don Morse. Re: Removing Reel Seat
Posted by:
Tom Kirkman
(Moderator)
Date: June 18, 2013 06:09PM
The difficulty in removing a seat without damage may preclude it being economically feasible to bother with. Try one and decide for yourself.
............. Re: Removing Reel Seat
Posted by:
Mark Iannacone Sr
(---.hsd1.nj.comcast.net)
Date: June 18, 2013 07:00PM
Thanks for all the replies.I'll try the heat gun first.If it becomes to difficult then I'll just trash it. Sorry, only registered users may post in this forum.
|