SPONSORS
2024 ICRBE EXPO |
Re: Dec Wrap migrates off center line
Posted by:
Chester Kiekhafer
(---.client.mchsi.com)
Date: May 04, 2013 09:33PM
Thanks Billy,
I just has me PC completely cleaned and tweaked if you know what I mean. So I'm a little cautious about adding the software, but I sure would like to use it. Thanks again for everything that you have done and I'm looking forward to that thread packing tool when they come in. I've go four rod builds in front of me so I may have to continue to use what I've been using until they come in. Chester May your line be tight and your beverages be cold! Re: Dec Wrap migrates off center line
Posted by:
Billy Vivona
(---.nycmny.fios.verizon.net)
Date: May 04, 2013 10:11PM
Chester, I got them easrlier this week, they were not made properly so they went back adn am hoping that I get them back this week, and they are made correctly. Thank you for waiting, and I apologize for taking so long. Re: Dec Wrap migrates off center line
Posted by:
Chester Kiekhafer
(---.client.mchsi.com)
Date: May 04, 2013 10:27PM
No need to apologize, it was out of our control. Chester May your line be tight and your beverages be cold! Sorry, only registered users may post in this forum.
|