SPONSORS
2024 ICRBE EXPO |
Cut Down Castaway xp3 874
Posted by:
Jeremy Reed
(---.hc.fewpb.net)
Date: April 29, 2013 07:54PM
I had an unfortunate accident with a door and butt end of a xp3 874 that left me with a 6'8" blank. I had some nice grips glued on, but that was it, so while it wasn't good, it could have been worse. Has anyone cut the frog rod down this much? How did it perform at 6'8"
Thanks, Jeremy Reed Reed Rods Re: Cut Down Castaway xp3 874
Posted by:
Chuck Mills
(---.grenergy.com)
Date: April 30, 2013 12:53PM
Well, you could extend it back to original length. Just a thought. _________________________________________ "Angling is extremely time consuming. That's sort of the whole point." - Thomas McGuane Re: Cut Down Castaway xp3 874
Posted by:
Jeremy Reed
(205.204.248.---)
Date: April 30, 2013 02:55PM
I had thought about it but don't have any material for extensions. And I actually like the length of it now, I was just curious if anyone has had any luck cutting it down much. Re: Cut Down Castaway xp3 874
Posted by:
J.B. Hunt
(---.pool.dsl.logantele.com)
Date: May 02, 2013 05:54PM
Re-build it and use it . I don't think you would notice the Power loss. Action is supposed to go slightly moderate. You can handle any Bass in Ky Lake with it. I prefer a 6' 8" myself. J.B.Hunt Bowling Green, KY Sorry, only registered users may post in this forum.
|