SPONSORS
2024 ICRBE EXPO |
Re: polishing tru oil coated cork handle?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: December 18, 2012 02:46PM
Larry,
If you haven't already, do one handle with epoxy guide finish - two coats - sanding between coats and tell us what you think of the results. Roger Re: polishing tru oil coated cork handle?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: December 18, 2012 03:49PM
I have just done a casting rod two - nice - coats sanding each Then a thin coat when all was level
When dry a - Red - scotch pad to take the shine off The finish will give the cork a Golden Tone to it and accent any added rings added to the handle The shine is nice but I like the flat look Bill - willierods.com Sorry, only registered users may post in this forum.
|