SPONSORS
2024 ICRBE EXPO |
rod wrapper
Posted by:
Bill Cohen
(---.dhcp.embarqhsd.net)
Date: November 15, 2012 04:08PM
Have a Pac. Bay Power wrapper and would like to up date the motor to ..... I don't know what its called but Its got the word clutch, in other words when the rod is spinning you can place your hand on the rod and it stops the blank from turning this is in the drying mode. Not quite sure if there is anything out there that will fit my existing wrapper Re: rod wrapper
Posted by:
Tom Kirkman
(Moderator)
Date: November 15, 2012 04:19PM
Flex Coat makes such an animal but I have no idea if it will fit your PacBay machine.
.............. Re: rod wrapper
Posted by:
Steve Hartzell
(---.hsd1.tx.comcast.net)
Date: November 15, 2012 04:21PM
[www.mudhole.com]
I think this is what you are looking for. and it should clamp right into the jaws on your wrapper. Be advised that there is a screw inside the rubber boot that allows you to adjust the tension. When I got mine I didn't realize that and had to really clamp down on the rod to make it stop. Loosening that screw a little made all the difference in the world. Steve Hartzell Lake Conroe - Willis, Texas Re: rod wrapper
Posted by:
Donald Newenhouse
(---.dhcp.embarqhsd.net)
Date: November 15, 2012 08:11PM
Yep ! I use the slip clutch on my Pac Bay wrapper, however I do have the upgraded jaws.And like Steve said, it does have a tension screw in the center. It was a bear at first,with carpal tunnel in both hands ,until someone on the fourm advised me about the screw. Purchased mine from Mudhole .... <<<<DON>>>> Fort Myers Fla. Sorry, only registered users may post in this forum.
|