SPONSORS
2024 ICRBE EXPO |
Factory Cork Tape Grip
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: October 20, 2012 05:34PM
Had a Friend bring me a Well known New factory rod to Shorten the Butt for him,After cutting and adding the new Butt cap I noticed a Gap in the Cork tape. Not in the Spiral but acrossed the tape! Grip was installed in Three pieces and the joints are Terrible the other gap was worse
The masking tape is on the Edge of the tape [www.rodbuilding.org] Edited 1 time(s). Last edit at 10/20/2012 05:38PM by Barry Thomas Sr. Re: Factory Cork Tape Grip
Posted by:
mike taillefer
(---.mco.bellsouth.net)
Date: October 24, 2012 07:49PM
youre lucky its on the end so you can hide it with a butt cap. Sorry, only registered users may post in this forum.
|