SPONSORS
2024 ICRBE EXPO |
Thanks To Roger Wilson
Posted by:
Jeremy Reed
(---.owb.bellsouth.net)
Date: September 02, 2012 10:17PM
I'd just like to thank Roger Wilson for wiring up the motor end of a home made rod wrapper in progress. Mr. Wilson offered to help in the wire up of a foot control, dc motor, power supply, and reverse switch and I took him up on it. I had a number of people to send me emails and offer help/suggestions with the project. I'm still working on it, but it's going at a much slower pace since I ran across a clemens lathe a couple weeks ago at a good price.
-Jeremy Reed Re: Thanks To Roger Wilson
Posted by:
Bill Davis
(---.dr02.atmr.al.frontiernet.net)
Date: September 03, 2012 10:53AM
No big surprise; Roger's just that way. Re: Thanks To Roger Wilson
Posted by:
Barry Thomas Sr
(---.hsd1.nj.comcast.net)
Date: September 03, 2012 12:21PM
He did all the Work needed to convert my Clemens to DC, Works like a charm! Re: Thanks To Roger Wilson
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: September 03, 2012 12:25PM
Jeremy,
My pleasure. Roger Sorry, only registered users may post in this forum.
|