SPONSORS
2024 ICRBE EXPO |
1.5" foam core needed
Posted by:
Eric Viburs
(---.hsd1.mn.comcast.net)
Date: August 13, 2012 09:00PM
Looking for a few sections for a Muskie rod I am working on. I will have a 14" lower and 5" upper (finsihed) if somebody has one made up let me know I would gladly buy it and pay shipping.
Thanks much, Eric Re: 1.5" foam core needed
Posted by:
Col Chaseling
(---.lnse3.cht.bigpond.net.au)
Date: August 13, 2012 09:21PM
Hi Eric,
I just ordered the chemicals and socks etc to make some but they won't be done for at least a month and I'm a long way from you. Making your own moulds is not difficult from some pvc tube etc. If you haven't read check Tom's article in Rodmaker 10-6 on doing it. ESFNEM Col Port Kembla, NSW Australia Re: 1.5" foam core needed
Posted by:
Tom Kirkman
(Moderator)
Date: August 13, 2012 09:37PM
Mickel's Custom Rods (link to the left) has some, I think. But Sammy travels during the week so it might be end of the week before you can get ahold of him.
............ Re: 1.5" foam core needed
Posted by:
Chuck Mills
(---.gctel.stellarllc.net)
Date: August 13, 2012 09:43PM
Eric - I have one. In the raw it is 1.5" x 14"+.
Send your mailing address to chuck@woodsmenrods.com _________________________________________ "Angling is extremely time consuming. That's sort of the whole point." - Thomas McGuane Sorry, only registered users may post in this forum.
|