SPONSORS
2024 ICRBE EXPO |
one more ? LOL!
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: August 10, 2012 10:54AM
anyone know if Titebond III, will this glue rubberized cork ring to the cork grip, I am asking since it has that rubber spots in the cork. Hope to hear from someone soon. Re: one more ? LOL!
Posted by:
Curtis Ellison
(---.yhti.net)
Date: August 10, 2012 12:22PM
I have used it on several handles with no issues.
This rod was built in 2010 and is holding up great. [www.rodbuilding.org] Curtis Re: one more ? LOL!
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: August 10, 2012 01:08PM
Thanks Curtis! its time to glue, have a good one! Re: one more ? LOL!
Posted by:
Phil Erickson
(---.dsl.pltn13.sbcglobal.net)
Date: August 10, 2012 06:20PM
It may work, but I have had two rubberized rod butts fail, Si I now use epoxy to be certain. I think it due to the fact that there is more rubber than cork in the composites. Re: one more ? LOL!
Posted by:
Eric Viburs
(---.hsd1.mn.comcast.net)
Date: August 11, 2012 07:41PM
That is all I use. I have tons of them out there with no issue. Ensure you clamp and that it is dry through. sometimes I will glue, allow time to dry, remove from mandrel and allow some more time as it will be wet on the inside. Re: one more ? LOL!
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: August 13, 2012 10:07AM
if you have rod bond use it Then clamp it Bill - willierods.com Sorry, only registered users may post in this forum.
|