SPONSORS
2024 ICRBE EXPO |
Dunlap woodlathe
Posted by:
Bill Eshelman
(---.neo.res.rr.com)
Date: August 02, 2012 05:22PM
I ran acrossa Dunlap lathe for a good price but have not been able to get ahold of the owner. Does any one know if it will accept a jacobs chuck?
Bill Ohio Rod Builders Canton, Ohio Re: Dunlap woodlathe
Posted by:
Tom Kirkman
(Moderator)
Date: August 02, 2012 05:32PM
Depends on the model. Dunlap made a variety of very good medium duty lathes for many, many years.
.............. Re: Dunlap woodlathe
Posted by:
gary Marquardt
(141.211.233.---)
Date: August 03, 2012 06:32AM
I had a Dunlap wood lathe for years and really liked it. mine took a Jacobs chuck on a #1 Morse taper. I picked the chuck up from Sears catalog but I think Penn State carries them also. Re: Dunlap woodlathe
Posted by:
Roger Templon
(---.proxy.aol.com)
Date: August 03, 2012 07:24AM
Bill
I also have an old Dunlap wood lathe. My chuck was purchased from Penn State Industries and also has a #1 Morse taper mount. Rog Re: Dunlap woodlathe
Posted by:
Bill Eshelman
(---.neo.res.rr.com)
Date: August 04, 2012 06:14PM
Thanks guys. I finally was able to get a hold of the seller, it does not have the taper but I bought it any how. The price was very good.
Bill Ohio Rod Builders Canton, Ohio Sorry, only registered users may post in this forum.
|