SPONSORS
2024 ICRBE EXPO |
EVA question
Posted by:
John Kitch
(---.mob.bellsouth.net)
Date: July 02, 2012 02:21PM
Will I be able to slip EVA with an I.D. of 3/4 inch over a 1 inch rod butt without additional reaming? I'm slidding it down from the tip emd.
Thanks John Re: EVA question
Posted by:
Tom Kirkman
(Moderator)
Date: July 02, 2012 04:15PM
It'll be very, very tough. If you follow the instructions on the FAQs page you might be able to do it, but I'd ream a bit more.
............. Re: EVA question
Posted by:
Bill Ballou
(---.hsd1.tn.comcast.net)
Date: July 04, 2012 08:01AM
if the eva is one color youshould be ok. Give it enough epoxy of choice. If it has some elliptical or other design then as tom said ream it alittle more. Sorry, only registered users may post in this forum.
|