SPONSORS
2024 ICRBE EXPO |
guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 12, 2012 04:41PM
i am a new rod builder BUT i can not find anything showing guide placment on all rods 15' 13' 12' 11' 7' and 6' if any one could help that would be great .... Re: guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 12, 2012 06:00PM
Thank you Tom!
I have been looking at all the pics people have posted an the workmanship is outstanding ,I wish there was people in my area that could mentor me on this art ,but there is no one well other then this message board..thanks once again... Tight Lines Gord Re: guide placment
Posted by:
Tom Kirkman
(Moderator)
Date: May 12, 2012 07:05PM
Where are you located?
............. Re: guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 13, 2012 08:30AM
Tom
I live in Niagara Fall Ontario In a little town called Fonthill. there is no one that builds rods here . tight lines Gord Re: guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 13, 2012 08:34AM
And also were cane i get this rodbuilding magazine Re: guide placment
Posted by:
Col Chaseling
(---.lns4.ken.bigpond.net.au)
Date: May 13, 2012 02:43PM
Hi Gordon,
Click on "Rodmaker Magazine" on the left and Tom will fix you up. ESFNEM Col Port Kembla, NSW Australia Re: guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 13, 2012 02:55PM
Canaidian link is not up and running for rodmaking magazine boo hoo Re: guide placment
Posted by:
Col Chaseling
(---.lns4.ken.bigpond.net.au)
Date: May 13, 2012 03:00PM
Hi Gordon,
If you can't get it up send Tom an email "[email protected]" or click on his name. Just brought the site up on my compuer and it says Canadian subscriptions are being done by "customtackle.com" ESFNEM Col Port Kembla, NSW Australia Edited 2 time(s). Last edit at 05/13/2012 04:33PM by Col Chaseling. Re: guide placment
Posted by:
Gordon Stuart
(---.home4.cgocable.net)
Date: May 13, 2012 05:12PM
yes and it will not go any further than that >>lol Re: guide placment
Posted by:
Zachary Kowasz
(---.nys.biz.rr.com)
Date: May 15, 2012 08:06AM
Hey Gordon, I'm also new to rod building, check out a website called anglers resource if you you need concept guide spacing for spinning rods. They have a a lot of good info and the use of GPS (Guide Placement Software) is free! Also look for articles on static guide placement, I've found some good ones out there but I couldn't tel you where because I've been looking so many things up!!! Re: guide placment
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: May 15, 2012 09:09AM
Hello Gordon & Zachary
Go to the top of this page clink on Library go down to the 9th article. If you dont have it, get Tom's book! (most of the folks on the left sell it) Tight Wraps. Bob, New Bern, NC. Sorry, only registered users may post in this forum.
|