SPONSORS
2024 ICRBE EXPO |
Source for just treaded tubing?
Posted by:
Thad Wells
(69.59.50.---)
Date: May 04, 2012 03:14PM
I am looking to buy some threaded tubing to make a fore grip. I am trying to make a custom grip similar to a Fuji HPS Quicklock. I just need something similar to 16 size tubing that would be needed. So I would need the tubing that goes on the rod and then some tubing that would thread onto the tubing on the rod. Any ideas? Re: Source for just treaded tubing?
Posted by:
Tom Kirkman
(Moderator)
Date: May 04, 2012 03:53PM
A skeleton seat barrel would serve as the threaded tubing. Fuji used to offer some quick-lock type foregrips pieces that were just internally threaded sleeves. Not sure if they still have them, but if you can run some down you can build pretty much anything you want to on them.
............... Re: Source for just treaded tubing?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: May 04, 2012 04:08PM
if you can do some thing with these it will be a little easier - Extend or shorten them to your needs
[www.mudhole.com] Bill - willierods.com Re: Source for just treaded tubing?
Posted by:
Phil Brenner
(198.217.64.---)
Date: May 05, 2012 06:41AM
These may be along the lines of what you are wanting. [www.mudhole.com] Re: Source for just treaded tubing?
Posted by:
Thad Wells
(---.we.res.rr.com)
Date: May 06, 2012 08:09AM
HPS Quick Lock is what I'm using now. I was hoping there was something I could use that just had threads. But I need the sleave and the tubing that would be glued to the rod. Right now I am using the HPS as the sleeve and a piece of a skeleton real seat for the tubing. Just looking to make it cheaper. Sorry, only registered users may post in this forum.
|