SPONSORS
2024 ICRBE EXPO |
Fuji ACS Trigger Reel Seat, can I build my own arbor?
Posted by:
norman schultz
(---.ykwc.com)
Date: March 13, 2012 02:28PM
One and a half inches of cork removal or build an arbor for fit? could send back and get correct size Re: Fuji ACS Trigger Reel Seat, can I build my own arbor?
Posted by:
Don Ahart
(---.hsd1.nj.comcast.net)
Date: March 13, 2012 03:50PM
Since the ACS has a hole to allow the to be blank seen/exposed. I would exchange it for the right size. Re: Fuji ACS Trigger Reel Seat, can I build my own arbor?
Posted by:
Terry Turner
(---.hsd1.or.comcast.net)
Date: March 13, 2012 05:24PM
You are better off getting the right size. Not sure how big your gap is, but sometimes you can add one layer of tape to the top side of the seat, and build an arbor for the front and rear of the seat as well. It does need to fit very snug so there is no gap or glue line around the exposed blank area.
Still best to get the right size, which is hard unless you try them out on the blank before bringing it home. Terry Sorry, only registered users may post in this forum.
|