SPONSORS
2024 ICRBE EXPO |
How to determine straighest axis on these rods?
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: November 28, 2011 10:35PM Re: How to determine straighest axis on these rods?
Posted by:
Don Morse
(---.dsl.sfldmi.sbcglobal.net)
Date: November 28, 2011 10:58PM
LOL ______________________________________ Super Tight Lines......Don Re: How to determine straighest axis on these rods?
Posted by:
mike harris
(---.cluster-h.websense.net)
Date: November 29, 2011 08:26AM
Throw 4 Alabama rigs and have 20 baits in the water at once, how would you explain it to the ranger if you exceeded your limit on a single cast……. Re: How to determine straighest axis on these rods?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 29, 2011 09:14AM
I am wondering how they use one reel and 4 lines ?? LOL Bill - willierods.com Re: How to determine straighest axis on these rods?
Posted by:
Don Morse
(---.dsl.sfldmi.sbcglobal.net)
Date: November 29, 2011 10:39AM
bill boettcher Wrote:
------------------------------------------------------- > I am wondering how they use one reel and 4 lines > ?? LOL Good point Bill, I didn't think about that ______________________________________ Super Tight Lines......Don Re: How to determine straighest axis on these rods?
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: November 29, 2011 11:51AM
Hello Bill
The same way you do a Dec wrap with 4 threads! (very carefully). Bob, New Bern, NC. Re: How to determine straighest axis on these rods?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 29, 2011 12:10PM
I was thinking of that ?? Did not think it possible ??Got to make one heck of a birds nest though LOL Bill - willierods.com Re: How to determine straighest axis on these rods?
Posted by:
Rufus Rhoden
(---.hsd1.fl.comcast.net)
Date: November 29, 2011 12:12PM
Putting the line on the reel is the easy part. Casting them would be the hard part, if one lure is cast at a much greater velocity than the others the lines are going to cross in the reel and tangle. Rufus Port Saint Lucie, FL Re: How to determine straighest axis on these rods?
Posted by:
JIM MOWL
(---.stat.centurytel.net)
Date: November 29, 2011 12:59PM
I never would have thoght it would cast without tangling. Mut have four lines spliced to one. Funny as heck! Re: How to determine straighest axis on these rods?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 29, 2011 01:09PM
Careful some may want to buy these ??? Bill - willierods.com Re: How to determine straighest axis on these rods?
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: November 29, 2011 01:43PM
Hey Bill
How about putting spacers on the reel spool? left edge of reel spool --> l l l l i<-- right edge of reel spool! Like that! Bob, New Bern, NC. Re: How to determine straighest axis on these rods?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 29, 2011 02:23PM
Hay Bob
I not going to build any of these I was just joking But thanks for the info Bill - willierods.com Re: How to determine straighest axis on these rods?
Posted by:
Robert A. Guist
(---.nmci.navy.mil)
Date: November 29, 2011 02:32PM
Bill
Ditto! Bob, New Bern, NC. Sorry, only registered users may post in this forum.
|