SPONSORS
2024 ICRBE EXPO |
CP on blank
Posted by:
Brandon Gay
(---.dsl.crchtx.sbcglobal.net)
Date: November 13, 2011 05:39PM
Here is what I got. An open wrap, A decal going on the bottom/ tip side about 2 1/2in long. I need to CP the thread work, but I have had problems in the past with CP dulling when applied on top of 1st coat of finish. So my question is: Is it OK to CP the entire wrap and section of bare blank where decal is on the underside and not have the blank come out dulled? The dulling I have seen as been when CP'n the edges of decals and it leaves sort of a halo around the decal. I want to CP the entire wrap and blank section where decal is. Re: CP on blank
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: November 13, 2011 06:06PM
IMHO it is better to CP the wrap Only Then clear the wrap and clear the area where the decal will go
When dry then apply the decal Bill - willierods.com Sorry, only registered users may post in this forum.
|