SPONSORS
2024 ICRBE EXPO |
Blank coating
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: October 04, 2011 03:32PM
i know this stuff has been talked about a loooog time ago
But i was wondering if any one has used it as a blank coating [www.klasskote.com] Thanks Bill - willierods.com Re: Blank coating
Posted by:
Joe Azar
(---.sub-174-252-210.myvzw.com)
Date: October 04, 2011 08:24PM
I haven't used this brand, but I have used acrylic urethane in a number of applications.
Namely to seal wood molds for casting polymer concrete. Big molds, holding anywhere from 10 to 8000 pounds of material. The molds held up fine for multiple uses. I have used it to seal the Hull of wooden boats. In fact I have a 1952 Dunphy perch that is my next project. I ran across this same product while researching this boat. I'm going to use it. It should perform well as a blank coating. You may have to play with mixing small amounts. Good luck. Always learning with Ohio Rod Builders Joe Azar Sorry, only registered users may post in this forum.
|