SPONSORS
2024 ICRBE EXPO |
How much to elongate?
Posted by:
Kurt Mogensen
(---.1.28.71.dynamic.ip.windstream.net)
Date: August 30, 2011 01:15PM
I am doing the Rose pattern from Billy's book and it calls for elongating the pattern. The butt wraps I have done to date have been straight squares so I don't have experience to draw on. My blank is 25mm diameter at the center of the wrap and I plan to do 6 passes. How much should I elongate this measurement to get a good pattern? Re: How much to elongate?
Posted by:
Herman Knott
(---.static.acsalaska.net)
Date: August 30, 2011 03:29PM
I happen to be working on a set of pink rods and also am wanting Roses.
My first 2 trys dident come out to good. Mine come out wide and short ????? Thanks Re: How much to elongate?
Posted by:
Kurt Mogensen
(---.1.28.71.dynamic.ip.windstream.net)
Date: August 30, 2011 03:58PM
Well, unless I hear differently i am going to strecth my 25mm to 30mm. That is a 20% elongation. We'll see if that is enough. Re: How much to elongate?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: August 30, 2011 04:14PM
E-Mail Billy
He wrote the book Bill - willierods.com Re: How much to elongate?
Posted by:
Mark Fisher
(---.lns6.fli.bigpond.net.au)
Date: August 30, 2011 06:41PM
20% should be plenty. I did one a while back which was based on 20% and the shape and size worked out pretty well spot on. Re: How much to elongate?
Posted by:
Billy Vivona
(---.nycmny.fios.verizon.net)
Date: August 31, 2011 06:51AM
I will multipl the spacings by either 1.25 or 1.5. You are on the right track with a 20% increase, because the photos of The Rose wrap in the book are 20% elongated.
PS: I will answer all questions about wraps on the forums, I prefer to do that as opposed to direct e-mail, but it a day passes and you do not hear form me e-mail me and give me a head's up, Re: How much to elongate?
Posted by:
Mark Blabaum
(---.yousq.net)
Date: August 31, 2011 06:54AM
This post reminded me to ask a question. How do you elongate a pattern in Visual Wrap? I'm not great with the builder part of the program so I probably missed some thing simple, but is there a function in the builder that will figure the percentage for you? Sorry, only registered users may post in this forum.
|