SPONSORS
2024 ICRBE EXPO |
FUJI ECSM - Need Help on Castaway 965
Posted by:
Jeremy Reed
(---.dhcp.insightbb.com)
Date: April 19, 2011 06:47PM
I've built two spinning rods, so my building is very limited. I am building a deep cranker on a castaway 965 and plan on using the ecsm seat. Since I have never built a exposed blank seat, I need help in knowing what to order.
Here are my measurements - I will be trimming 1 1/4" off the butt, so the measurements below are after the 1 1/4" is trimmed. 14.37mm butt - 11" grip - 13.49mm - ecsm seat roughly 4 1/2" - 12.69mm - 2 1/2" foregrip - 12.35mm so the butt of the ecsm seat is 13.49 and the top is 12.69 winding check will be probably a 13mm for the 12.35 (so i have a little bit a play to add thread) I'm assuming a 13.5 or 14 on the reel seat, but wanted to double check before ordering. Thanks Edited 1 time(s). Last edit at 04/19/2011 06:58PM by Jeremy Reed. Re: FUJI ECSM - Need Help on Castaway 965
Posted by:
Lance Dupre
(---.mycingular.net)
Date: April 19, 2011 07:15PM
Jeremy give me a call tomorrow. I can help you out with your order and measurements. Lance Re: FUJI ECSM - Need Help on Castaway 965
Posted by:
mike harris
(174.136.133.---)
Date: April 20, 2011 01:29PM
I am sure Lance will get you dialed in, but always order a reel seat on the smaller side and ream it to fit. Sorry, only registered users may post in this forum.
|