SPONSORS
2024 ICRBE EXPO |
Chuck advice please
Posted by:
Ray Mazza
(---.syrcny.east.verizon.net)
Date: March 17, 2011 07:24PM
Just bought a new Jet 1014 and I plan to buy a 3 or 4 jaw chuck. I'm looking for some suggestions. Thanks in advance.
Ray Re: Chuck advice please
Posted by:
Tom Kirkman
(Moderator)
Date: March 17, 2011 07:30PM
I use a OneWay Talon chuck and wouldn't trade it for anything, but there are many good ones out there, some costing considerably less.
............ Re: Chuck advice please
Posted by:
Robert Metzger
(---.dyn.optonline.net)
Date: March 17, 2011 07:44PM
Check out Penn Stat Industries. Over the years I have
found them To offer good quality at reasonable cost. Re: Chuck advice please
Posted by:
wayne diduch
(---.cpe.net.cable.rogers.com)
Date: March 17, 2011 07:52PM
Ray, I'm with Tom on this one...i too, own a Oneway Talon... outstanding !! Re: Chuck advice please
Posted by:
Jim Gamble
(97.106.17.---)
Date: March 17, 2011 08:46PM
The Nova G3 is a good choice for midi lathes. Sorry, only registered users may post in this forum.
|