SPONSORS
2024 ICRBE EXPO |
H&H Rods
Posted by:
Bill Klarer
(---.pool.dsl.scrtc.com)
Date: February 15, 2011 01:50PM
A customer brought in an H&H rod and asked if I could repair/replace a guide that had lost the ring insert. I have searched for H&H Rods (Richmond, TX) and am guessing that they are no longer in business. I have not yet gotten into wrapping and was wondering if I could just replace the lost ring insert. The guides on either side of the one in question are 7.0 and 5.5. My Fuji catalogue does not list ring inserts, only guide frame/ring assemblies. Could a #6 ring be purchased and if so what would be the best way to secure it to the guide frame?
Thanks, Bill Klarer 502.415.3549 Re: H&H Rods
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: February 15, 2011 03:47PM
It would be easier to just replace the whole guide Bill - willierods.com Re: H&H Rods
Posted by:
Bill Klarer
(---.pool.dsl.scrtc.com)
Date: February 15, 2011 04:30PM
Thanks Bill. Re: H&H Rods
Posted by:
Spencer Phipps
(---.war.clearwire-wmx.net)
Date: February 16, 2011 10:50PM
Bill,
Are you measuring the inside or outside diameter of the rings for your measurement? Reason I asked is your 5.5 measurement, we usually don't see that size guide, we also use the OD of the ring, or the ID of the guide frame as our measurement. Re: H&H Rods
Posted by:
Bill Klarer
(---.pool.dsl.scrtc.com)
Date: February 17, 2011 07:14AM
Thanks for responding Spencer. This will prove to be a great learning experience for me. The inside diameter of the guide frame measures 8,35mm, with the frame wire at 0,70mm and the frame outside diameter measures 9,75mm. So I guess thee guide is a #8? Sorry, only registered users may post in this forum.
|