SPONSORS
2024 ICRBE EXPO |
How do you make a carbon fiber fighting butt
Posted by:
Bob Hallowell
(---.sub-199-74-155.myvzw.com)
Date: October 05, 2010 09:06AM
I made a carbon fiber grip for the last fly rod I made. In fact I made several and they turned out nice. But now I am getting ready to make a new steelhead rod for myself and I want to do the carbon fiber thing again but I will have a fighting butt. Do they make a CF sock the is closed on one end you can buy? any suggestions?
Thanks, Bob Re: How do you make a carbon fiber fighting butt
Posted by:
john timberlake
(---.triad.res.rr.com)
Date: October 05, 2010 09:26AM
make it like you did your handle then place a butt cap over the bottom to cover the hole. the cap can be anything that works. automotive panel fasteners are a good choice. you can also use the butt tack made by struble. this should give you some ideas Re: How do you make a carbon fiber fighting butt
Posted by:
Lane Pelissier
(---.sub-97-228-234.myvzw.com)
Date: October 05, 2010 09:29AM
You are going to have to attach some eva or rubberized cork to the carbon butt. I'm making one for a 10wt now. The auto body panel clips work well too.
Lane Edited 1 time(s). Last edit at 10/05/2010 09:32AM by Lane Pelissier. Re: How do you make a carbon fiber fighting butt
Posted by:
Chuck Mills
(---.grenergy.com)
Date: October 05, 2010 09:51AM
I've used the Mud Hole CRB Rubber Butt Cap Insert - [www.mudhole.com]
Here's a few examples... [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] Chuck _________________________________________ "Angling is extremely time consuming. That's sort of the whole point." - Thomas McGuane Edited 1 time(s). Last edit at 10/05/2010 09:52AM by Chuck Mills. Re: How do you make a carbon fiber fighting butt
Posted by:
Charles Lechner
(---.bankofamerica.com)
Date: October 07, 2010 04:52PM
john timberlake Wrote:
------------------------------------------------------- > make it like you did your handle then place a butt > cap over the bottom to cover the hole. the cap > can be anything that works. automotive panel > fasteners are a good choice. you can also use the > butt tack made by struble. this should give you > some ideas +1 Re: How do you make a carbon fiber fighting butt
Posted by:
John Straight
(---.netsync.net)
Date: October 10, 2010 10:51AM
I used a wooden dowel in the butt hole, colored with black sharpie marker and epoxied the heck out of it. No damage visible yet, if it scratches or dents give it some more epoxy. JLS Custom Rods Cassadaga, NY Edited 1 time(s). Last edit at 10/10/2010 10:53AM by John Straight. Sorry, only registered users may post in this forum.
|