SPONSORS
2024 ICRBE EXPO |
60 degree drill bits
Posted by:
Steve Johnson
(---.hsd1.fl.comcast.net)
Date: September 28, 2010 07:20PM
I have no idea where I first read it but I'm looking for a source for the 60 degree bits to make a mandrel fit properly on a live center.
Thanks for any help, Steve Re: 60 degree drill bits
Posted by:
Tom Kirkman
(Moderator)
Date: September 28, 2010 07:33PM
Grizzly Industrial or Smithy Inc. have them. They're called "end boring bits." RodMaker Magazine did a complete article on how to make your own mandrels and center bore the ends with the 60 degree tooling.
....................... Re: 60 degree drill bits
Posted by:
Steve Johnson
(---.hsd1.fl.comcast.net)
Date: September 28, 2010 07:49PM
Thanks Tom. I'm sure I have the magazine issue, I'll look there. "End boring bits" is what I was missing. Thanks again Re: 60 degree drill bits
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: September 28, 2010 08:11PM Re: 60 degree drill bits
Posted by:
keith osborn
(122.128.88.---)
Date: September 28, 2010 11:02PM
they are also known as centre bits and they come in various sizes, dormer make them as do irwin i believe Keith Osborn Niagara Pk Australia Re: 60 degree drill bits
Posted by:
Steve Johnson
(---.hsd1.fl.comcast.net)
Date: September 29, 2010 10:28PM
Thank you all. I found a few options from the sources listed above.
Steve Sorry, only registered users may post in this forum.
|