SPONSORS
2024 ICRBE EXPO |
same distant between micros the entire length of rod?
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: July 23, 2010 05:33PM
The 27x guide placement to place the choker guide, would it be ok to place all the guides equally, through out the whole rod? I plan on using size 2mm or 1.5 all down the rod, so, would you say that i didn't need to use the 27x guide choker thing or not? I'm just inquiring to see if anyone would have an idea on this difficult ?,lol! I'm ready to get the guides for my rod blank and want to choose the right and easiest placement! thank You! Re: same distant between micros the entire length of rod?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: July 23, 2010 06:04PM
The 27 X is basically for spinning rods Read this : New Guide Concept - Spinning Rods [www.rodbuilding.org] Bill - willierods.com Re: same distant between micros the entire length of rod?
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: July 23, 2010 06:46PM
If you are building a spinning rod (for which the 27x method was designed)
The answer is yes on guide spacing from choker guide to tip and No! on the guide spacing from choker guide to reel. Read that article Bill suggested And I would suggest that if using 1.5 or 2mm running guides that you use a 3.5 mm for the choker guide. Reading the articles in RodMaker Vol. 10 issue #4 and vol. 11- issue #1 written on this subject will prove to be quite valuable to you and may save you some extra work. Re: same distant between micros the entire length of rod?
Posted by:
lorenzo tellez
(---.hsd1.il.comcast.net)
Date: July 23, 2010 06:56PM
Thank you, Steve, I will keep that in mind when I build my spinning rod, I guess I'll just use all the same size for the casting crank bait rod I am now building, teh shaky head rod is next, spinning! Re: same distant between micros the entire length of rod?
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: July 24, 2010 09:36AM
Just make sure any knots pass though the rings you want to use. Bill - willierods.com Sorry, only registered users may post in this forum.
|