SPONSORS
2024 ICRBE EXPO |
Tom K.(or others) question about reel seat caps for winding checks...
Posted by:
Scott Nordlund
(209.62.248.---)
Date: June 16, 2010 03:05PM
Tom -
I'd like to use your technique with a rubber reel seat end cap for a winding check like you used here... [www.rodbuilding.org] How did you make a clean hole through the top? Thanks! Re: Tom K.(or others) question about reel seat caps for winding checks...
Posted by:
Tom Kirkman
(Moderator)
Date: June 16, 2010 03:14PM
A lathe makes it very easy. Pop the small end into a self centering chuck and just bore out the middle to the appropriate size. A higher RPM, 1500+ tends to give a cleaner cut. You can use a regular twist drill bit, just make sure it's sharp.
We covered this in detail in a past RodMaker article, but it's pretty simple to do just from the instructions above. ............. Re: Tom K.(or others) question about reel seat caps for winding checks...
Posted by:
Scott Nordlund
(209.62.248.---)
Date: June 16, 2010 10:36PM
thanks for the tip! Re: Tom K.(or others) question about reel seat caps for winding checks...
Posted by:
Karry Batson
(---.olympus.net)
Date: June 17, 2010 12:43PM
The Batson FBWC is overlooked because its not listed in our catalog. Here is a link to the web page so you can see how they look as another option. These will only fit size 16 casting and spin seat threaded side.
[www.batsonenterprises.com] Custom Winding Check System for Size 16 Casting Reel Seats Used Without Foregrips NEW 2009-2010 Item Number I.D.mm O.D.mm MSRP FBWC09.0 9.0mm (.35) N/A $1.08 FBWC09.5 9.5mm (.375) N/A $1.08 FBWC10.0 10.0mm (.4) N/A $1.08 FBWC10.5 10.5mm (.415) N/A $1.08 FBWC11.0 11.0mm (.433) N/A $1.08 FBWC11.5 11.5mm (.45) N/A $1.08 FBWC12.0 12.0mm (.475) N/A $1.08 FBWC12.5 12.5mm (.5) N/A $1.08 FBWC13.0 13.0mm (.512) N/A $1.08 FBWC13.5 13.5mm (.53) N/A $1.08 FBWC14.0 14.0mm (.55) N/A $1.08 Karry Batson Batson Enterprises Inc. Ph: (877) 875-2381 Fax: (360) 683-3579 karry@batsonenterprises.com www.batsonenterprises.com Sorry, only registered users may post in this forum.
|