SPONSORS
2024 ICRBE EXPO |
Bent Butt Handle O.D. (not ferrule)
Posted by:
Tom Locke
(---.c3-0.wob-ubr2.sbo-wob.ma.cable.rcn.com)
Date: March 23, 2010 06:21PM
Hi all,
I am researching building a bent butt IGFA 130# rod for targetting giant bluefin tuna. The rods will never leave the swivel rodholders so the butt is important. Does anyone have info on the handle outside diameter of the different manufacturers of the #4 and #6 size curved aluminum butts? I am trying to figure out which butt will fit securley in the holder. Thanks, Tom Re: Bent Butt Handle O.D. (not ferrule)
Posted by:
Mark Griffin
(---.lsanca.fios.verizon.net)
Date: March 23, 2010 11:20PM
Your best bet is to post where you need the measurements . The largest O.D. on the bent butts is well above where they will sit in the rod holders. Post where the measurement is critical (gimbal to 9" above the gimbal for example) and the O.D.'s that people post will be more relevant to your application. Mark Griffin [] C&M Custom Tackle San Dimas, California Re: Bent Butt Handle O.D. (not ferrule)
Posted by:
Tom Locke
(---.c3-0.wob-ubr2.sbo-wob.ma.cable.rcn.com)
Date: March 25, 2010 06:59PM
Thanks to the AmTak guys for getting back to me. :-) Sorry, only registered users may post in this forum.
|