SPONSORS
2024 ICRBE EXPO |
micros
Posted by:
Cheng Moua
(---.hsd1.mn.comcast.net)
Date: March 02, 2010 10:52PM
i will be in the process of building 3 casting rods for bassin' soon. all of which will have micros on them - spiral wrapped. 2 are 7' med-hvy mod-fast action rods. the other one is a 6'6" med-hvy fast action rod. how many guides do i need for the 7 footers and how many guides do i need for the 6'6"? where approximately do i place the guides on these rods? what sizes do i use? are these just used for the running guides or can the entire set of guides be micros?
thanks! Re: micros
Posted by:
bill boettcher
(---.dyn.optonline.net)
Date: March 03, 2010 08:27AM
Good starting place is -- one guide per foot -plus one, not counting the tip top. Then static test.
Check out the two articles on the Library page Bill - willierods.com Re: micros
Posted by:
Steve Gardner
(---.nc.res.rr.com)
Date: March 03, 2010 11:02AM
Chung;
here they are in order vol.#1 [www.rodbuilding.org] vol. #2 [rodbuilding.org] Vol. #3 [rodbuilding.org] Vol. #4 [rodbuilding.org] Vol. #5 [rodbuilding.org] Could not fid volume #6 It may have gotten killed back when the site hacked with a virus Vol. #7 [rodbuilding.org] Sorry, only registered users may post in this forum.
|