SPONSORS
2024 ICRBE EXPO |
how to begin
Posted by:
thom daub
(---.15.141.238.res-cmts.dun.ptd.net)
Date: February 14, 2010 08:05PM
i m just beginning to become a rod builder i could use help in setting up work bencdh and all infromation i cuold possibly can from my fellow builders.
thank thom thom daub Re: how to begin
Posted by:
thom daub
(---.15.141.238.res-cmts.dun.ptd.net)
Date: February 14, 2010 08:08PM
my spelling is bad not use to using computers sorry Re: how to begin
Posted by:
Jeremy Wagner
(---.dhcp.embarqhsd.net)
Date: February 14, 2010 08:49PM
Thom,
If you are looking to get into rod building, you've come to the right place. First, I would recommend reading through the library and the glossary to familiarize yourself with terms and procedures. Then, I'd recommend getting a good book on rod building such as Tom Kirkman's book. Then, dive in. It's usually best to purchase minimal tools and inexpensive components to get started. When you've built a rod or two, then you can decide what tools you find necessary and what techniques work best for you. You don't need anything fancy to get started. I started out using a cardboard box for a hand wrapper and I slowly added tools from there. jeremy Sorry, only registered users may post in this forum.
|