SPONSORS
2024 ICRBE EXPO |
Aluminum window spin seat
Posted by:
Matt Davis
(64.118.9.---)
Date: December 05, 2009 02:48PM
I'd swear I've seen them somewhere recently but I'll be darned if I can find them now.
Is anyone making a spin seat out of aluminum with a window in it? My customer really likes the AW12 Window seat with woven tubing from American Tackle. But its in a fly configuration with the end for inletting into a fly grip. This may have to do, but would much rather have a spin configuration. Thanks in advance. ....................................... Better to have and not need than to need and not have. Re: Aluminum window spin seat
Posted by:
Timothy Johnson
(---.37.132.111.adsl.snet.net)
Date: December 05, 2009 04:00PM
Pac Bay makes an aluminum size 18mm spinning window seat with rosewood under it I think. Re: Aluminum window spin seat
Posted by:
Joe Vanfossen
(---.neo.res.rr.com)
Date: December 05, 2009 05:46PM
Matt,
Check Netcraft under metal reel seats. You may need to see if you can find a graphite insert to fit. Joe Re: Aluminum window spin seat
Posted by:
Gary Henderson
(---.mco.bellsouth.net)
Date: December 05, 2009 09:22PM
Check out American Tackle seats at Mudhole. Re: Aluminum window spin seat
Posted by:
Rob Adams
(---.mia.bellsouth.net)
Date: December 06, 2009 06:49AM
Look at the Alps reel seats. They have a nice seat that has a texalium insert.
CA-TRI-AH12M-B 102.6mm (4.03) 11.10mm (0.437) on this page at the batson site. -->[www.batsonenterprises.com] I just used one of these to make a light spinner. Filed off and polished the ridge in the back to make it a bit more comfortable in hand. Rob Re: Aluminum window spin seat
Posted by:
Matt Davis
(64.118.9.---)
Date: December 06, 2009 08:20AM
Thanks guys.
Not sure how I missed those... Rob - What did you use to polish that seat? .............................. Better to have and not need than to need and not have. Re: Aluminum window spin seat
Posted by:
Rob Adams
(---.mia.bellsouth.net)
Date: December 06, 2009 10:04PM
Matt Davis Wrote:
------------------------------------------------------- > > > Rob - What did you use to polish that seat? > .............................. After I filed it, I used some 600 grit wet sand paper, then a dremel tool with a wire brush, then buffing pad. Rob Davie, FL Rob Davie, FL Sorry, only registered users may post in this forum.
|