SPONSORS
2024 ICRBE EXPO |
Double over bind advice
Posted by:
Adam Gatehouse
(---.24.168.202.static.comindico.com.au)
Date: October 04, 2009 10:06PM
Hi All,
Just a quick question, if I was to do a double over bind would I run the thread up the guide foot then back down and tie off, or run up tie off then run up a second time and tie off again? Thanks Adam Re: Double over bind advice
Posted by:
Tom Kirkman
(Moderator)
Date: October 04, 2009 10:13PM
You can do it without tying off in-between. Just make a careful reverse, pushing the thread back one thread width and then change direction.
.................... Sorry, only registered users may post in this forum.
|