SPONSORS
2024 ICRBE EXPO |
New Pac Bay Lathe Add-Ons
Posted by:
Marc Morrone
(---.dsl.airstreamcomm.net)
Date: August 20, 2009 09:57AM
Has anyone seen the new tailstock and tool rests for the Pac Bay lathes? They are supposed to be for turning on a mandrel. Re: New Pac Bay Lathe Add-Ons
Posted by:
Spencer Phipps
(---.ptld.qwest.net)
Date: August 20, 2009 10:02AM
Talked to them last week about the tool rest, they have some in, but haven't got them on the site or priced out yet. Re: New Pac Bay Lathe Add-Ons
Posted by:
Mark Griffin
(---.lsanca.dsl-w.verizon.net)
Date: August 20, 2009 10:39AM
The MSRP on the Tool Rest is $59.95 and the MSRP on the Tailstock is $89.95.
We haven't set our prices yet, but should have these up on the site sometime next week when they come in. Mark Griffin [] C&M Custom Tackle San Dimas, California Re: New Pac Bay Lathe Add-Ons
Posted by:
Raymond Adams
(---.hsd1.ca.comcast.net)
Date: August 20, 2009 11:21AM
I saw both units at the West Coast Custom Rod Show last May and was very impressed! Raymond Adams Eventually, all things merge, and a river runs through it.. Sept. Field & Stream
Posted by:
Edwin Kime
(---.dsl.wchtks.sbcglobal.net)
Date: August 20, 2009 08:18PM
My issue of the Sept. Field and Stream had a simple sprial in it for a bass rod. Showing how it could be made. Had see pictures of them in magazines but not a small article like this. Hope the rod companies does not pick up on this.
Edwin Kime Sorry, only registered users may post in this forum.
|