SPONSORS
2024 ICRBE EXPO |
Rod Blanks and parts
Posted by:
Rusty Byrley
(---.houston-06rh15rt.tx.dial-access.att.net)
Date: July 29, 2009 10:33PM
I'm going to be heading East thru Birmingham, Chattanooga, Knoxville, Bristol, Roanoke and all the way to Charlottesville Va. and wondered if anyone knew any Rod Blank and parts distributors in any of these areas along my way. I looked in the directory and found a builder in Bedford Va. and hope to contact him when I get there. I know there used to be one in Shelbyville, Tennesee but they sold out to Mudhole last week. Re: Rod Blanks and parts
Posted by:
Bill Stevens
(---.br.br.cox.net)
Date: July 30, 2009 08:47AM
From Houston on !-10 Baton Rouge is first stop for gas - at 70 mp 4.132 hours - Side trip to Swampland Warehouse #2 five minutes from 10/12 Split!
Blanks, Micros, Grips Sets, Demo Micro Rods, Free Boudin and lotsa smiles! Come See Sha! Re: Rod Blanks and parts
Posted by:
Bill Ballou
(---.hsd1.tn.comcast.net)
Date: July 30, 2009 09:27AM
There is a builder in Cleveland, Tn. John Miles He is just a few minutes off exit 27. Cleveland is about an hour north of Chattanooga. Fine gentleman and builds nice rods. Hope he has what you are looking for. His phone is423-479-8808. Good luck on your trip-Bill Sorry, only registered users may post in this forum.
|