SPONSORS
2024 ICRBE EXPO |
Lathe Instructions
Posted by:
Tom Kirkman
(Moderator)
Date: July 01, 2009 11:04AM
In an earlier thread I mentioned that I had prepared a set of instructions at the request of Renzetti, Inc. several years ago. I was not aware that they are not including them with the lathes.
Anyone that wishes a copy can request one by sending an email to this address: rodmaker@earthlink.net Please do not request one by posting here on the forum. I do not have the photos that go along with the instructions, but if you have one of these units you may still find this helpful. ................ Sorry, only registered users may post in this forum.
|