SPONSORS
2024 ICRBE EXPO |
Quality EVA
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: September 18, 2008 08:58PM
I am looking for some quality EVA to build a couple of deep jigging rods. The last batch I used was a bit soft which made shaping quite easy. However, it did not stand up to use very well. Please advise. Re: Quality EVA
Posted by:
Rohit Lal
(---.riv12.nsw.optusnet.com.au)
Date: September 18, 2008 09:27PM
I have found pacific Bay EVA to be good. Lasts very well on hard used rods and the new batches appear to be very firm and dense. Re: Quality EVA
Posted by:
Chris Beverley
(218.185.73.---)
Date: September 18, 2008 10:14PM
Terry
By far, the toughest and best quality EVA I have encountered is the Super Support stuff available from Matagi. It is very dense and shapes well. If you use 120 grit screen, you get a nice finish. It is very firm and does not dent easily. Cheers Chris Re: Quality EVA
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: September 19, 2008 12:50AM
Thanks. Does any of our sponsors carry these two types of EVA? Re: Quality EVA
Posted by:
Scott Sheets
(---.hsd1.il.comcast.net)
Date: September 19, 2008 08:00AM
You might want to ask Lance Dupree where their EVA is from. It is very dense, much better than any other EVA I have tried. Scott Sheets www.smsrods.com Re: Quality EVA
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: September 19, 2008 09:47PM
Padron my ignorance. How do I contact Lance Dupree? Re: Quality EVA
Posted by:
Tom Bittick
(---.cartcmta01.crthmo.lr.dh.suddenlink.net)
Date: September 19, 2008 11:28PM
Lance is the owner of Swampland. [www.swamplandtackle.com] Sorry, only registered users may post in this forum.
|