SPONSORS
2024 ICRBE EXPO |
Re: Decal connections "peel and sticks"
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: September 27, 2007 12:38PM
I now have my decal on and it looks good, I burnished it onto the finish and then heated it with a heat gun to warm up the decal and help make sure it stuck.
Mark, that 1/2 cut trick of yours worked GREAT!!! As did Scott's little "trim off the excess" edge. You guys are GREAT!! Thanks for all the help, it sure made the decal job a LOT easier for me. One more question.......how long do I wait before adding finish over it? DR Re: Decal connections "peel and sticks"
Posted by:
Mark Blabaum
(---.dsl.mhtc.net)
Date: September 27, 2007 01:11PM
You should be able to apply finish right away. Re: Decal connections "peel and sticks"
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: September 27, 2007 01:46PM
Thanks Mark,
I'm headed at it :-) DR Re: Decal connections "peel and sticks"
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: September 27, 2007 11:22PM My long decal turned out very well, not perfect, but pretty darn good. If the backing were a touch clear-er it would be perfect. All the tips and tricks really made things much easier, Thanks! to all the good eggs out there that helped make it possible! :-) DR Sorry, only registered users may post in this forum.
|