SPONSORS
2024 ICRBE EXPO |
multi rod turner
Posted by:
Anonymous User
(---.cable.mindspring.com)
Date: September 10, 2007 04:43PM
I found a website that had pictures of a Multi rod curing machine. It had two approx 8" discs separated about 3' apart with notches around the discs with dowel rod stubs at each notch. He used rubber bands
to hold the rod butt and tip and the whole thing turned at a slow speed to cure the epoxy. Anyway I can't find the website and I need it. Somebody please help. Re: multi rod turner
Posted by:
Rena Hall
(---.oc.oc.cox.net)
Date: September 10, 2007 05:01PM
Go to the photo Board and lookup Tom Kirkman's pictures of his mulit-rod dryer.
Rena (Pink Lady) Re: multi rod turner
Posted by:
Anonymous User
(---.cable.mindspring.com)
Date: September 10, 2007 05:38PM
Thanks Rena! This is even simpler than the one I saw. It sure will give me a start on building my own.
Bill Re: multi rod turner
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: September 11, 2007 03:26AM
The one comment about the rod dryer that is posted on the photo pages is that it is a great design. However, many folks might want to consider the idea of making it longer and to use ball bearing supports at each end of the center shaft - rather than cantilivering the shaft from one end. Of course, this assumes that you have a place to install it.
Take care Roger Re: multi rod turner
Posted by:
Anonymous User
(---.cable.mindspring.com)
Date: September 11, 2007 07:22PM
Thanks Roger, I will definately keepthat in mind Thanks again and Thanks Rod Forum! Sorry, only registered users may post in this forum.
|