SPONSORS
2024 ICRBE EXPO |
Aftco lightweight roller tip
Posted by:
wes morikawa
(---.lsanca.fios.verizon.net)
Date: August 03, 2007 10:55AM
What is the best way to put these tips on? Should I be concerned about heating the tube since it is not metal?
Thanks Re: Aftco lightweight roller tip
Posted by:
Fred Halfheimers
(---.milwpc.com)
Date: August 03, 2007 11:47AM
I like to epoxy them on because of the heat issue. Re: Aftco lightweight roller tip
Posted by:
wes morikawa
(---.lsanca.fios.verizon.net)
Date: August 03, 2007 12:47PM
Thanks for the reply. What type and brand of epoxy do you use? Re: Aftco lightweight roller tip
Posted by:
Fred Halfheimers
(---.milwpc.com)
Date: August 03, 2007 01:23PM
I use the Devcon 5 minute, I get it at wal mart for $1.97... you can heat it to remove if you have to,, but you gotta be quick.. Re: Aftco lightweight roller tip
Posted by:
Scott Parsons
(---.nc.res.rr.com)
Date: August 03, 2007 02:55PM
I use Thread master Ultimate gel 5 min it is great also. Sorry, only registered users may post in this forum.
|