SPONSORS
2024 ICRBE EXPO |
Unified Wheel
Posted by:
Ralph D. Jones
(---.bhm.bellsouth.net)
Date: February 12, 2007 07:48PM
I bought a unified wheel from Bingham Enterprises a few weeks ago and I finally bought a 1/4in. arbor to use the wheel on my lathe. What is the maximum safe rpm. to use the unified wheel? Ralph If at first you don't succeed, go fishing, then try, try again. Re: Unified Wheel
Posted by:
Anonymous User
(Moderator)
Date: February 12, 2007 07:49PM
You can turn it at the usual AC motor speed. The wheel won't fragment or come apart.
.............. Re: Unified Wheel
Posted by:
Ralph D. Jones
(---.bhm.bellsouth.net)
Date: February 12, 2007 11:23PM
Thanks, Tom. Ralph Re: Unified Wheel
Posted by:
Don Randall
(---.ca.astound.net)
Date: February 13, 2007 02:37AM
I recently purchased the Morton Guide Spacing Chart from Renzetti. Does anyone have any better instructions re: set up and use other than the one that came with the chart? Re: Unified Wheel
Posted by:
Anonymous User
(Moderator)
Date: February 13, 2007 09:07AM
Much better instructions are in the Volume 4 #6 issue of RodMaker. I edited those to make them far easier to understand.
However, now that I've said that, I have to mention that that back issue is sold out. It is, however, on the new RodMaker Volume 4 CD. I will have these at the show this weekend and they'll be up on the website in a couple weeks. Talk to anyone who has the chart from Renzetti and they'll tell you the instructions are a mess. I'm going to speak with Andy this weekend about that one and the one he includes with his lathe. Both need to be vastly improved. ................... Sorry, only registered users may post in this forum.
|