SPONSORS
2024 ICRBE EXPO |
finish for decals
Posted by:
Chris May
(---.lsanca.dsl-w.verizon.net)
Date: November 27, 2006 10:44PM
I have built about a dozen rods over the last couple of years and did not put decals on any of them. I would like to do so now (while I can still remember the details). I would rather not mix a batch of epoxy finish (which I used for the rods) for each decal application. I only have the capacity to dry one rod at a time. Can Permagloss be used effectively for this application? If so, how many coats would usually be needed?
Thanks, Chris Edited 1 time(s). Last edit at 11/27/2006 10:56PM by Chris May. Re: finish for decals
Posted by:
Mike Barkley
(---.try.wideopenwest.com)
Date: November 28, 2006 12:21AM
If you put PG firectly on to the decal, it will probably dissolve it as it's pretty hot. Cover the decal with CP or artict's fixitive to seal it. I don't know a lot about PG but if you are talking about rods over a few days old, I would think that the surface would have to be scuffed to a water break free status and the whole area will have to be recoated. Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Sorry, only registered users may post in this forum.
|