SPONSORS
2024 ICRBE EXPO |
Trimming recoil feet.
Posted by:
bill boettcher
(---.an3.nyc41.da.uu.net)
Date: June 10, 2006 10:13AM
I was wondering if I will have any trouble if I trim the spin re coil guide feet down a little ?? They are a little long.
They don't come apart do they ??? Re: Trimming recoil feet.
Posted by:
Spencer Phipps
(---.onsemi.com)
Date: June 10, 2006 10:55AM
They are soldered together so I wouldn't use much heat in reshaping the foot. I think we've had seperation problem posts before when they first started using them. Re: Trimming recoil feet.
Posted by:
bill boettcher
(---.nas77.newark2.nj.us.da.qwest.net)
Date: June 10, 2006 11:13AM
Thanks Spencer I'll remember to keep them cool. Re: Trimming recoil feet.
Posted by:
Tim Rumlow
(---.dhcp.fdul.wi.charter.com)
Date: June 10, 2006 02:21PM Spence, I use a rotary tool at low speed, and then finish up w/ sandpaper, they turn out fine...and they still flex just fine also... Tim Sorry, only registered users may post in this forum.
|