SPONSORS
2024 ICRBE EXPO |
problem with scratches on wrap finish
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: March 24, 2006 09:20PM
I've got terrible scratches on the surface of my wrap finish -- one application of flexcoat lite build. I was messing with guide placement for an acid wrap rod & didn't realize that the finish was still a little tacky.
Is there anything that I can do? Thanks Terry Re: problem with scratches on wrap finish
Posted by:
Steve Gardner
(---.dyn.sprint-hsd.net)
Date: March 24, 2006 09:49PM
put another coat on it
Re: problem with scratches on wrap finish
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: March 24, 2006 10:26PM
Thanks Steve. So, I don't have to sand it down or anything?
Terry Re: problem with scratches on wrap finish
Posted by:
Steve Gardner
(---.dyn.sprint-hsd.net)
Date: March 24, 2006 10:33PM
If they are wide scratches you might, but if they were caused be your finger prints. they should level out and fill in. You might try picking the worse one and recoating that one only. That should tell you if another coat will work, or you need to sand them down or start over. I've had some pretty bad goobers of my own that I've just been able to recoat, and they came out fine. Re: problem with scratches on wrap finish
Posted by:
terry truong
(---.dsl.okcyok.sbcglobal.net)
Date: March 25, 2006 12:58AM
Thanks.
Terry Sorry, only registered users may post in this forum.
|