SPONSORS
2024 ICRBE EXPO |
Fuji handle cap
Posted by:
Dan Leitzen
(---.dhcp.roch.mn.charter.com)
Date: February 27, 2006 02:16PM
I just received a new fuji handle kit and the but cap does not slide all the way up on the cork. It slides up about a 1/4 inch and the cap is made of a soft rubber. So 3/4 of the cap is empty. I have never seen this . Is there anything special to do to epoxy the cap on? Re: Fuji handle cap
Posted by:
Mark Griffin
(---.lsanca.dsl-w.verizon.net)
Date: February 27, 2006 03:05PM
Dan,
My Son uses a lot of these grip sets and simply places the cork far enough up the blank to accomodate a couple of tape bushings at the rear of the blank to support the cap. It's just like setting up a grip on a saltwater blank with a 2" or 3" cap. If you'd like to contact him, he'd be happy to guide you further. His email address is mike@@#$%& Good luck! Mark Griffin [] C&M Custom Tackle San Dimas, California Re: Fuji handle cap
Posted by:
Spencer Phipps
(---.lsil.com)
Date: February 27, 2006 03:07PM
Is there a shoulder on the cork that the cap has butted up against? If not and you have a ways to go to get it there take some sandpaper and evenly take a little cork off till it bottoms out on the shoulder. Usually there will be a little empty space left in the can, like maybe 1/4 inch or so. Sorry, only registered users may post in this forum.
|