SPONSORS
2024 ICRBE EXPO |
winding check
Posted by:
Steve Smotherman
(---.fuse.net)
Date: January 01, 2006 06:13PM
I want to add a metal winding check Ive used rubber in the past how do I order the right size?Do I go buy the butt dia of the blank? the butt dia of the blank is .420 the struble winding check is .422 is that close enough?
Steve Re: winding check
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: January 01, 2006 06:22PM
You need to know the diameter of the blank where the winding check will go and get one a tad bigger to allow for flexing of the blank, Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Re: winding check
Posted by:
Ken Preston
(---.longhl01.md.comcast.net)
Date: January 01, 2006 06:23PM
Steve -
The winding check is going to go above the fore grip - measure the blank diameter where the for grip will end (have to account for taper of the blank). Re: winding check
Posted by:
Tom Nair
(---.ptldor.dsl-w.verizon.net)
Date: January 01, 2006 08:03PM
If you get the two next sizes down from your butt diameter, one will work just fine. Re: winding check
Posted by:
Jeff Shafer
(---.phil.east.verizon.net)
Date: January 01, 2006 10:03PM
Steve,
I just emailed an Excel file to you. The file is one of the tabs in an Excel file that I use as my rod building journal. In the file I correlated the nickel silver winding checks that Cabelas offers to bare blank diameters, to the same diameter with one coating of size A nylon thread, and to the same diameter with two coatings of size A nylon thread. I like having one layer of thread as a cushion under a rigid nickel silver ring. Good Luck, Jeff Shafer Re: winding check
Posted by:
Ed Grella
(---.37.151.40.adsl.snet.net)
Date: January 01, 2006 11:00PM
If you are sliding it over one or two coats of high buid over a diamond wrap, you might want to get one size larger than the blank. Checks are cheap so order a few different diameters. Ed Re: winding check
Posted by:
Steve Smotherman
(---.fuse.net)
Date: January 01, 2006 11:50PM
Thanx guys I was wanting to order everything at once so ill try the one size down from the butt dia and order a couple other sizes
Steve Sorry, only registered users may post in this forum.
|