SPONSORS
2024 ICRBE EXPO |
trim on Forham wraps
Posted by:
Bruce A. Tomaselli
(---.dioceseaj.org)
Date: December 07, 2005 09:30AM
I'm building a spinning rod with single foot guides and plan on using the Forham locking wrap. I would like to put on silver trim wraps. Can I put a trim wrap on the end of the Forham wrap? Re: trim on Forham wraps
Posted by:
Stan Grace
(---.hln-mt.client.bresnan.net)
Date: December 07, 2005 09:42AM
It shouldn't be a problem. You may need to experiment a little depending on the method you use. Stan Grace Helena, MT "Our best is none too good" Re: trim on Forham wraps
Posted by:
Bruce A. Tomaselli
(---.dioceseaj.org)
Date: December 07, 2005 09:49AM
Hi Stan! I used the nail knot method on my last rod and I really liked it. Thanks Re: trim on Forham wraps
Posted by:
Stan Grace
(---.hln-mt.client.bresnan.net)
Date: December 07, 2005 11:50AM
That method should work with the Forhan wrap as the trim band can be wrapped and then slid into place. I only trim on the ramp end of the guide but see no reason it couldn't be applied on either end. Stan Grace Helena, MT "Our best is none too good" Re: trim on Forham wraps
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: December 07, 2005 12:28PM
I do it the way Stan suggests. Put the band with the nail knot, slide it into place an tighten it down. I put a tiny dab of CP on the "knot" to hold it in place (some use Super Glue on a pin) I use Forhan wraps and put the trims on both ends of the wrap
Mike (Southgate, MI) If I don't want to, I don't have to and nobody can make me (except my wife) cuz I'm RETIRED!! Sorry, only registered users may post in this forum.
|